SHAFT 2P1028 - Caterpillar

Injury to personnel can result if they are not in the operator's view. Allow only essential personnel near the machine, and make sure the personnel are in the operator's view when testing, to prevent injury. Make sure checks are done in an open area.
Personal injury can result from rotating and moving parts.Stay clear of all rotating and moving parts.Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.The machine must be parked on a level surface and the engine stopped.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g01360589
Move propulsion lever (3) to the NEUTRAL position.
Rotate speed dial (2) to the MINIMUM position.
Move parking brake switch (1) to the ON position.
Illustration 2 g01360596
Move screed lift switch (4) to the RAISE position. Completely lift the screed.
Illustration 3 g01360600
Engage screed lock mechanism (5) on both sides of the machine.
Move screed lift switch (4) to the FLOAT position. Note: The screed lift switch on the inactive instrument panel must also be in the FLOAT position in order to lower the screed.
Illustration 4 g01360601
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (7) to the OFF position.
Move engine start switch (7) to the ON position. Do not start the engine.
Illustration 5 g01360604
Press home key (8).
Illustration 6 g01360626
Press down key (9) until "Service" is highlighted on the display screen.
Press "OK" key (10).
Illustration 7 g01360637
Press down key (9) until "Calibrations" is highlighted on the display screen.
Press "OK" key (10).
Illustration 8 g01360639
Press down key (9) until "Lt Station Propel Lvr" is highlighted on the display screen.
Press "OK" key (10).
Press "OK" key (10) in order to begin the calibration.
Illustration 9 g01360640
Illustration 10 g01360643
Move operator station select switch (11) to the LEFT position.
Press "OK" key (10).
Illustration 11 g01360645
Move propulsion lever (3) on the left instrument panel to the NEUTRAL position.
Press "OK" key (10).
Illustration 12 g01360646
The display should now read "CALIBRATION COMPLETE". Push back key (12) in order to return to the calibration screen.
Push home key (8) in order to exit the calibration screen.
Move engine start switch (7) to the OFF position.