SHAFT 2Y7194 - Caterpillar

Illustration 1 g06221191
Front view of cab
Table 1
Item Qty Part Specification Description
1 12 - Torque to 14 2 N m (124 18 lb in).
2 6 - Tighten inner nut to 13 2 N m (115 18 lb in).
Tighten outer nut to 38 2 N m (28 2 lb ft)
Ensure to hold inner nut steady while tightening outer nut.
3 35 3S-2093 Cable Strap Ensure that the tie straps should secure not constrict hose(s).
As required, use the cable straps.
4 - - Torque to 2.5 0.5 N m (22.1 4.4 lb in).
Illustration 2 g06221179
Right view of cab
Table 2
Item Qty Part Specification Description
5 2 8T-5400 Connector Torque to 0.80 0.15 N m (7.08 1.33 lb in).
6 - - Torque to 9 1 N m (80 9 lb in).
Illustration 3 g06221402
Rear view of cab
Table 3
Item Qty Part Specification Description
7 - - Torque to 7.5 0.5 N m (66.4 4.4 lb in).
8 - - Torque to 9 1 N m (80 9 lb in).
9 - - Use the following procedure to install the wiper arm:
1. Tighten nut to 21 1 N m (186 9 lb in).
2. Wait for minimum of 0.5 hours to 4 hours maximum.
3. Again, tighten nut to 21 1 N m (186 9 lb in).
Illustration 4 g06221463
8T-5400 Connector
Table 4
Item Qty Part Specification Description
10 - - Torque for sheet metal is 0.35 0.05 N m (3.10 0.44 lb in).
Use the following procedure for glass installation:
1. Initially tighten to 0.35 0.05 N m (3.10 0.44 lb in).
2. Wait for a minimum of 0.5 hour and 4 hours maximum.
3. Again, tighten to 0.35 0.05 N m (3.10 0.44 lb in).