SHAFT-RKR-YM 3148711 - Caterpillar

Install plug (37) in valve body (26) . Tighten plug (37) to a torque of 50 7 N m (37 5 lb ft).
Illustration 11 g00728312
Install two pistons (36) , two springs (35) , two springs (34) , and two O-ring seals (33) in valve body (26) .
Illustration 12 g00728297
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Note: Line up the orientation marks made during disassembly.
Install plate (33) and bolts (32) on valve body (26) . Install bracket (31) and install washers and bolts (30) .
Illustration 13 g00728292
Install O-ring seal (29) on valve body (26) .
Illustration 14 g03368381
Note: Line up the orientation marks made during disassembly.
Install valve body (26) . Install washers and bolts (28) . Install six washers and two bolts (27) . Install O-ring seal (25) .
Illustration 15 g03368389
Install plate (24) on brake control valve (1) .
Illustration 16 g00728217
Install O-ring seal (20) , screen (21) , O-ring seal (22) , and rectangular seal (23) on cartridge assembly (19) .
Illustration 17 g00728209
Install cartridge assembly (19) in manifold (6) . Tighten cartridge assembly (19) to a torque of 30 3 N m (22 2 lb ft). Install coil (18) , washer (17) , and nut (16) on cartridge assembly (19) . Tighten nut (16) to a torque of 9.5 1.5 N m (85 13 lb in).
Illustration 18 g00728204
Install O-ring seal (12) , screen (13) , O-ring seal (14) , and rectangular seal (15) on cartridge assembly (11) .
Illustration 19 g00728198
Install cartridge assembly (11) in manifold (6) . Tighten cartridge assembly (11) to a torque of 30 3 N m (22 2 lb ft). Install coil (10) , washer (9) , and nut (8) on cartridge assembly (11) . Tighten nut (8) to a torque of 9.5 1.5 N m (85 13 lb in).
Illustration 20 g00728175
Install O-ring seal (7) in manifold (6) .
Illustration 21 g03368390
Install manifold (6) on brake control (1) . Install four washers (5) on manifold (6) .
Illustration 22 g03368393
Install plate (4) on brake control (1) . Install washers and four bolts (3) . Tighten bolts (3) to a torque of 30 4 N m (22 3 lb ft). Install four cable straps (2) .End By: Install the brake control valve. Refer to Disassembly and Assembly, "Brake Control Valve - Install".