SHAFT GP-DRIVE 3562439 - Caterpillar

Front Axle Group
Illustration 1 g01289718
260-8698 Front Axle Gp (ALL WHEEL DRIVE)
Table 1
Specifications for 260-8698 Front Axle Gp    
Callout     Description     Specifications    
1     Thickness of washer     1.52 0.23 mm (0.060 0.009 inch)    
Dimension (A)
1.5 mm (0.06 inch)    
2     Torque for two nuts    
220 30 N m (162 22 lb ft)    
3     Final Drive     Fill with 5P-1228 Oil to the level that is indicated on the outer cover    
4     Torque for the ball stud nut    
220 14 N m (162 10 lb ft)    
B     Minimum gap under retainer    
0.03 mm (0.0012 inch)    
C     Gap between washer and ring    
1.6 0.5 mm (0.063 0.020 inch)    
D     Minimum gap under retainer    
0.03 mm (0.0012 inch)    Note: Use washer (1) in order to maintain the maximum gap (A) .Note: Grease the pin and the bearing prior to assembly.Note: Tighten the nut to correct torque. Increase torque to align the nut to the next cotter slot.Note: This gap is on both ends of the pin.Note: Both sidesNote: This gap is on both ends of the pin.
Illustration 2 g01289766
(5) 260-8704 Bar
Table 2
Specification for 260-8704 Bar    
Callout     Description     Specification    
E     2G-8631 Sleeve Bearing depth of installation    
7.5 0.4 mm (0.295 0.016 inch)    Axle Assembly
Illustration 3 g01427579
(6) 260-8699 Front Axle Gp
Table 3
Specification for 260-8699 Front Axle Gp    
Callout     Description     Specification    
F     Installation depth of bearing sleeve    
7.2 0.5 mm (0.28 0.02 inch)    
G     Installation depth of sleeve bearing on both ends    
7.2 0.5 mm (0.28 0.02 inch)    Note: Install the bearing so that the part number is visible from the outside of the assembly.
Illustration 4 g01427582
Section A-A
Table 4
Specification for 260-8699 Front Axle Gp    
Callout     Description     Specification    
H     Installation depth of bearing    
1.2 0.5 mm (0.05 0.02 inch)