SHAFT AS-REVERSE 4441423 - Caterpillar

Illustration 1 g02077653
Schematic of the Screed Raise SolenoidThe Screed Raise Solenoid is located behind the LH Machine side panel. The solenoid is part of the bank of nine solenoids.
Illustration 2 g02211494
Machine LH Side Panel Open
Illustration 3 g02211358
Solenoid Bank behind LH side panel
Illustration 4 g02219353
View from below of the Solenoid bank (1) Park Brake Solenoid (Wire 374-PK) (2) Counterbalance Lock Solenoid (Wire X771-YL) (3) Auger Raise Solenoid (Wire 787-WH) (4) Screed Float Solenoid (Wire A905-GN) (5) Screed Raise Solenoid (Wire F742-PU) (6) Counterbalance Solenoid (Wire T841-PK) (7) Counterbalance Standby Solenoid (Wire T840-PU) (8) Auger Lower Solenoid (Wire 781-PK) (9) Propel Mode (Gear) Shift Solenoid (Wire 334-BU)This diagnostic code is associated with the Screed Raise Solenoid (5). The FMI 03 means that the LH Operator ECM has detected that the voltage of the solenoid circuit is above normal or that the ECM has detected voltage in the circuit when no voltage should be present.Note: The LH Operator ECM is located under the LH Operator Platform.Conditions that could cause this diagnostic code to be activated are:
The energize circuit of the solenoid is shorted to another voltage source.
The ECM has failed. This situation is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. System Response:When this diagnostic code is active, the following occurs:
Screed will move to the fully raised position.
Operator station fault lamp is active.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness at the solenoid for the Screed Raise hydraulic valve. Disconnect the