SHAFT GP-DRIVE 4646904 - Caterpillar

3304B Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Check the condition of the gaskets. If the gaskets are worn or damaged, use new parts for replacement.
Illustration 1 g00590134
(1) Position pipe (7) on the engine block. Install bolts (4) and clamp (1). (2) Place oil cooler (2) and the gasket in position on the pipe (7). Install bolts (4).End By: Install the engine oil filter and the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install". 3306B Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the condition of the gaskets. If the gaskets are worn or damaged, use new parts for replacement.
Illustration 2 g00468428
Install engine oil cooler (2) and three bolts (4). Connect clip (3) for the engine oil level gauge. Connect hose assembly (5) .
Illustration 3 g00468427
Tighten two hose clamps (1) .End By: Install the engine oil filter and the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".