SHAFT ASSEM. 4D7847 - Caterpillar

Safety Section
The Safety Section lists basic safety precautions.Read and understand the basic precautions listed in the Safety Section before operating or performing maintenance and repair on this service tool.General Information Section
The General Information Section describes tooling functions and features. This section provides useful information on individual parts, additional tooling, and resources.Operation Section
The Operation Section is a reference for the new operator and a refresher for the experienced operator.Photographs and illustrations guide the operator through correct procedures for using the tool group.Operating techniques outlined in this publication are basic. Skill and techniques develop as the operator gains knowledge of the service tool and tool capabilities.Maintenance Section
The Maintenance Section is a guide to tool inspection, cleaning, storage, and tool disposal.Safety Section
Safety Icon Nomenclature
Personal Protection/Important Information
Illustration 2 g02166423
Personal Protection/Important InformationHazard Avoidance
Crushing Hazard (body)
Crushing Hazard (foot)
Crushing Hazard (hand)
Pinch Point
Working Load Limit (WLL) mark - Do not use lifting device unless load identification (WLL) markings are legible.
Safety Alert - Do not use lifting device for anything other than the intended purpose. General Information Section
Illustration 3 g03322931
Introduction
The 385-1152 Rear Suspension Lifting Device is used to remove and install rear suspension cylinders from 793 Off-Highway Trucks safely.Additional Contact Information
For additional product support questions concerning this tool, contact the Dealer Service Tools Hotline at:USA: 1-800-542-8665, Option 1International: 1-309-578-7372Email: dealerservicetool_hotlineNomenclature
Specifications
Table 1
Tool Specifications    
Dimensions     1875.47 mm (6.15 ft) high x
768.9 mm (2.5 ft) long x
460 mm (1.5 ft) wide    
Weight    
88.9 kg (196 lb)    
Working Load Limit (WLL)    
907.18 kg (2000 lb)    Operation Section
Operation
Illustration 4 g03322931
Slide tool around bottom of the suspension cylinder. Tool will cradle the upper section of the cylinder.
Fasten ratchet strap around the upper section of suspension cylinder.
Attach a suitable lifting device to top of the tool. Four lifting holes are available to allow for easy center of gravity lifting.
Move cylinder into position.Maintenance
Inspection
Inspect all welds and check for damaged, cracked, or bent components. Inspect tooling prior to each use. If damage is found, destroy the tool and dispose of as scrap. Replace damaged tool with new product.
Do not use unless the Working Load Limit (WLL) identification markings are legible.
Do not use if lifting holes in vertical tubes are elongated.
Do not use if hardware is damaged or missing.
Have the tools inspected annually by an approved dealership inspector.Cleaning
Clean the tooling with a non-solvent based cleaner.Storage
Store the tooling in a clean, dry location to prevent rust or corrosion. Tooling can be damaged by moisture or high humidity.
The tool should be stored in the most stable position.Tool Disposal
At the end of the operational life of the tool, destroy the tool and dispose of as scrap.