SHAFT 4D9757 - Caterpillar

Illustration 1 g03015399
Table 1
Specification for 365-0752 Track Roller
Item Qty Part Specification Description
1 4 137-3301 Bolt Torque to 270 40 N m (199 30 lb ft).
Illustration 2 g03015576
Table 2
Item Qty Part Specification Description
2 2 171-5883 Duo-Cone Seal Gp Rubber toric seals and all surfaces that in contact with the seals must be clean and dry at assembly. Prior to assembly apply, a thin layer of 6V-4876 Lubricant to the surfaces that are in contact with the metal seals. The metal seal must be assembled square with the bore. The rubber toric seals must not bulge. The rubber toric seals must not be twisted.
3 2 1H-8128 O-Ring Seal During assembly, lubricate the bore with the lubricant that is being sealed.
4 2 124-8248 Bushing During assembly, lubricate the outside surface of the bushing.
5 2 217-6359 Collar Lubricate the bore lightly with the lubricant that is being sealed.
A - - Distance to the bushing from the face of the roller on each side is 17.50 0.08 mm (0.689 0.003 inch).
B 1 6Y-0454 Stopper As The stopper assembly must not be recessed below the surface of the stopper after assembly.
Dimension for installing the stopper below the end of the shaft is 11 4 mm (0.4 0.2 inch)
C 1 217-6358 Shaft Extension of the shaft from the surface of the collar on both side is 53.25 0.13 mm (2.096 0.005 inch).
- - - Minimum end play is 0.25 mm (0.010 inch).
Maximum end play is 1.23 mm (0.048 inch).