SHAFT 4N1911 - Caterpillar

Connect the hoses to valve (102) and secure to the machine.
Illustration 60 g03797814
(30) 376-3020 Cover
(78) 8T-4121 Hard Washer
(80) 8T-4137 Bolt
Install cover (30) over valve (102).Lubrication Wiring Group
Location
Illustration 61 g03802456
(33) 376-4757 Front Harness As
(35) 440-5371 Wiring HarnessInstallation
Illustration 62 g03802597
(7) 7K-1181 Cable Strap
(35) 440-5371 Wiring Harness
(70) 4P-7581 Clip
(78) 8T-4121 Hard Washer
(80) 8T-4137 Bolt
Install wire harness (35) to the pump and route as shown. Secure to the pump support assembly.
Illustration 63 g03802938
(A) Chassis Harness
(7) 7K-1181 Cable Strap
(35) 440-5371 Wiring Harness
(55) 204-1611 Strap
(57) 204-8000 Cable Tie Mounting
(61) 344-5675 Nut
(78) 8T-4121 Hard Washer
Route wire harness (35) as shown. Connect to chassis harness (A). Secure harness (35).
Illustration 64 g03803029
(B) Wire Harness
(7) 7K-1181 Cable Strap
(33) 376-4757 Front Harness As
(49) 132-5789 Clip
(78) 8T-4121 Hard Washer
(79) 8T-4136 Bolt
Connect wire harness (33) to wire harness (B) and route as shown. Secure to the bracket assembly.
Illustration 65 g03803055
(7) 7K-1181 Cable Strap
(33) 376-4757 Front Harness As
(98) 452-7178 Lubrication Distribution Valve Gp
Connect wire harness (33) to valve (98) and secure in place.Automatic Lubrication System Monitoring
Select the Trans/Chassis ECM in Cat ET.
Navigate to the configuration page.
Expand the Machine Configuration menu.
Illustration 66 g03553579
Select "Auto Lube System Installation Status"
Illustration 67 g03553585
Select "Installed" from the drop-down menu in the window that appears.
Illustration 68 g03553597
Click "Yes" and confirm you want to program this parameter in the next popup window.
You may need to key cycle the ECM to complete the installation. Turn the key start switch to the Off position, wait 2 minutes seconds then turn the key switch back to the On position. Confirm the parameter has been programmed.