SHAFT-AXLE 5036512 - Caterpillar

5036512 SHAFT-AXLE Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5036512
503-6512
5036512

Weight: 99 pounds 44 kg.

Buy SHAFT-AXLE 5036512 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Genuine OEM HVAC Air Inlet Housing For Dodge Durango 68224169AB

$231.56

11 Sep 2024

US: Newparts

Genuine OEM HVAC Air Inlet Housing For Dodge Durango 68224169AB
Newparts

Number on catalog scheme: 1

Caterpillar 5036512 Parts scheme SHAFT-AXLE

For full view, you need register

Information:

Start By:
Separate the final drive and the wheel from the service brake. Refer to Disassembly and Assembly, "Final Drive and Wheel from Service Brake - Separate".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00369332
Illustration 2 g00369333
Remove plates (1) and friction discs (3) from brake housing (2).
Illustration 3 g00369334
Remove hub (4) from the brake housing.
Illustration 4 g00369335
Use Tooling (A) in order to remove retaining ring (5) from hub (4).
Illustration 5 g01447153
Illustration 6 g01447155
Install Tooling (B) on brake housing (2). The large plate is installed under the springs.
Illustration 7 g01447534
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Use Tooling (B) in order to compress the springs. Remove pins (6) from the guides.
Illustration 8 g00369342
Use Tooling (B) in order to release the spring tension and remove Tooling (B). Remove guides (8) and springs (7).
Illustration 9 g00369343
Remove piston (9) from the brake housing.
Illustration 10 g00369344
Remove seal (10) from the brake housing.
Illustration 11 g00369345
Remove seal (11) from the brake housing.
Illustration 12 g00369346Note: Thrust washer (12) is bonded to brake housing (2). Do not remove thrust washer (12) unless the thrust washer is worn or damaged. Refer to the following steps for the removal of thrust washer (12).Note: Do not apply heat directly to the brake housing. Excessive heat may reduce the service life of brake housing (2).
Remove screws (13). Raise the temperature of thrust washer (12) in order to release the material that was used for bonding.
Remove thrust washer (12) from brake housing (2).