parts catalog

SHAFT AS-OUT 5088213 - Caterpillar

5088213 SHAFT AS-OUT Caterpillar parts SHAFT
Alternative (cross code) number:
Caterpillar 5088213 SHAFT AS-OUT

Buy SHAFT AS-OUT 5088213 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 1 g01457009
(1) Oil fill/drain plug
(2) Oil check plug
Position one final drive so that the oil fill/drain plug (1) is at the top. Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
Use an 8 mm (5/16 inch) allen wrench. Remove the oil check plug (2).
Check the oil level. The oil should be near the bottom of the opening for the oil check plug (2).
Add oil through the opening for the oil fill/drain plug (1), if necessary. Note: Overfilling the final drive will cause the seals on the travel motor to allow hydraulic oil or water to enter the final drive. This may contaminate the final drive.
Clean the oil plugs.
Install the oil plugs. Tighten the oil plugs to a torque of 27 1 N m (20 0.7 lb ft).
Repeat the procedure for the other final drive.

Parts shaft Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.