SHAFT-BEVEL GE 5488457 - Caterpillar

Engine Oil and Filter
Change
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
The percentage of sulfur in the fuel will affect the engine oil recommendations. If the fuel has over 0.5% sulfur content, the engine oil must have a TBN of 20 times the percentage of fuel sulfur (TBN as measured by the ASTM D-2896 method). If the sulfur content is greater than 1.5%, consult your Caterpillar dealer for correct engine oil recommendations.Fuel sulfur is chemically changed during combustion to form sulfuric acid. The acid chemically attacks metal surfaces and causes corrosive wear. Higher engine oil TBN values are essential to minimize corrosive wear. Change Oil
Change oil with warm engine only. Remove drain plug (Fig. 534) from engine crankcase and allow the oil to drain. Install drain plug. Fill the crankcase with oil through filler (Fig. 779) until oil level reaches the upper mark on dipstick. Start the engine and let it turn for a short time. Stop the engine and check oil level again.Change Filter Element
Loosen filter (1, Fig. 536) with a filter strap wrench or screwdriver and remove by hand. Coat the rubber seal of the new filter with clean engine oil. Install the new filter by hand. When the seal contacts the base, tighten an additional 1/2 turn. Follow the "Operation" Guide of the engine manufacturer. Fan Belt Tension
Check
Refer to the operating instructions of engine manufacturer.Hydraulic Fluid Tank
Clean Breather Filter
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.Use all cleaning solutions with care.
Unscrew filter (1, Fig. 538) and wash thoroughly. Allow filter to dry before refitting. Parking Brake
Check
The plunger of the spring brake cylinder (Fig. 690) should not move more than 68 mm (2.68 inch) from the position brake released to brake engaged. If 68 mm (2.68 inch) or less are measured, install new brake shoes. See "Adjust Parking Brake" in the "When Required" section of this guide.With the parking brake engaged a hydraulic safety locking device prevents moving the machine. Swing Brake
Check Fluid Level
The brake fluid container is situated in the cab at the right-hand front side. The level of the brake fluid should be no more than 10 mm (.38 inch) below the upper edge of the container (4, Fig. 576).