SHAFT 5H6875 - Caterpillar

Install bearing cone (21), bearing cone spacer (20) and bearing cone (19) in idler gear (15).
Illustration 36 g00505482
Apply clean hydraulic oil on O-ring seal (17). Install O-ring seal (17) on shaft assembly (18).
Illustration 37 g00505508
Install 1/2" - 13 NC guide pin (61) in shaft assembly (18).
Hold transfer gear (15) in position in torque converter housing assembly (2). Install shaft assembly (18).
Remove guide pin (61) from shaft assembly (18).
Illustration 38 g00505517
Install bolt (14) that holds shaft assembly (18) in place in torque converter housing assembly (2). Tighten the bolt to a torque of 120 20 N m (90 15 lb ft).
Illustration 39 g00505572
Use the proper equipment to handle bearing cones (12). Heat bearing cones to a maximum temperature of 135°C (275°F). Install a bearing cone (12) on each side of pump drive gear (11).
Illustration 40 g00505585
Use the proper equipment to handle bearing cup (13). Lower the temperature of bearing cup (13). Install bearing cup (13) in torque converter housing assembly (2).
Illustration 41 g00505591
Install pump drive gear (11) in torque converter housing assembly (2).
Illustration 42 g00505594
Use the proper equipment to handle bearing cup (8). Lower the temperature of bearing cup (8). Install bearing cup (8) in pump adapter (6).
Illustration 43 g00505623
Install shims (9) on pump adapter (6).
Apply clean hydraulic oil on O-ring seal (10). Install O-ring seal (10) on pump adapter (6).
Illustration 44 g00505666
Install two 3/8" - 16 NC guide pins (62) in torque converter housing assembly (2).
Install pump adapter (6) on torque converter housing assembly (2).
Illustration 45 g00505669
Install thirteen bolts (5) and the washers.
Use Tooling (B) to check bearing end play. The bearing end play must be 0.15 0.05 mm (.006 .002 inch). Add or remove shims in order to get the correct bearing end play. Note: If end play is less than 0.10 mm (.004 inch) add additional shims. If end play is greater than 0.20 mm (.008 inch) remove shims.
Illustration 46 g00505670
Apply clean hydraulic oil on O-ring seal (4). Install O-ring seal (4) on torque converter housing assembly (2).
Illustration 47 g01022823
Install two 1/2" - 13 NC guide pins (63) in the carrier assembly.
Install Tooling (A) to torque converter housing assembly (2), as shown. Attach a hoist and suitable lifting chains to Tooling (A). Use the hoist to carefully install torque converter housing assembly (2) on the torque converter.
Illustration 48 g00503225
Install eight bolts (1) and the washers to torque converter housing assembly (2). Tighten the bolts to a torque of 120 20 N m (90 15 lb ft). End By:
Connect the torque converter to the transmission and to the output transfer gears. Refer to Disassembly and Assembly, "Torque Converter to Transmission, Output Transfer Gears - Connect" for the machine that is being serviced.