SHAFT 5S7608 - Caterpillar

Description
Illustration 1 g03604657I/O cabinetGenerator set module (GSM) optionThe generator set module start option (1) adds the following breakers to the I/O cabinet:
One breaker
Two breakers (CB11 and CB21)The breakers are located on the front panel at the bottom of the cabinet behind the door. Refer to Illustration 1 for the location. The GSM start option (1) allows the UPS to control generators in cases of lost utility power. Also, the GSM start option (1) allows the UPS to start the external generator set if power is lost.Refer to the following list of characteristics for the circuit breakers:
480 VAC
40 A
3 - poleRemoval Procedure
Refer to Systems Operation, Testing and Adjusting, UENR3954, "Internal Component Preremoval Steps (Input/Output Cabinet)" in order to shut down the system and gain access to internal components.
Disconnect the six wires that lead to the circuit breaker and from the circuit breaker. Verify the labeling on the wires with the location of the wires. Verify the labeling on the cables for subsequent installation.
Remove the four screws on the front of the breaker that secure the breaker to the rear of the cabinet.Installation Procedure
Illustration 2 g01271290
GSM panel
(2) GSM breaker 1
(3) GSM breaker 2
Attach the GSM circuit breaker (1) to the panel of the cabinet with four screws. Refer to Illustration 2.
Illustration 3 g03797531
Generator set module (GSM) breaker found in some units
(4) Breaker attachment screws
(5) Cable connector screws
Connect the wires from the cable landing and the generator set. Verify the labeling of the wires with the location of the wires.