SHAFT-BEVEL PINION 5V1273 - Caterpillar

Bucket Lift Lever
Float (1) - Push the lever all the way forward into detent, for FLOAT. The bucket will lower to the ground, and move up and down, following the ground contour.The lever will remain in FLOAT until pulled out of detent. The lever will then return to HOLD when released.
NEVER use FLOAT position to lower a loaded bucket.Machine damage can result from bucket falling too fast.
Float detent is not on machines equipped with load check system. LOWER (2) - Push the lever forward to lower the bucket. The lever will return to HOLD when released. HOLD (3) - The lever will return to HOLD when released from either RAISE or LOWER. The bucket will remain in the position it is in. RAISE (4) - Pull the lever back to raise the bucket. Release the lever to stop lifting the bucket. The lever will return to HOLD when released.The lever is detented in the full raise position. It will stay in detent and continue raising, until the bucket reaches height set by the lift kickout. Then it returns to HOLD.Bucket Tilt Lever
DUMP (1) - Push the lever forward to tilt the bucket forward. When released the lever will return to the hold position and the bucket will remain in the tilt forward position. HOLD (2) - Release the tilt lever. The bucket will remain in the position it is in. TILT BACK (3) - Pull the lever back to tilt the bucket back.Multifunction Control Lever
The multifunction control lever allows the operator to control the tilt and lift functions with a single lever. DUMP (1) - Move the lever to position (1) to dump the bucket. The lever will return to HOLD when released. HOLD (2) - The lever will return to HOLD when released. The bucket will remain in the position it is in. TILT BACK (3) - Move the lever to position (3) to tilt the bucket back. The lever will return to HOLD when released. LOWER (4) - Move the lever to position (4) to lower the bucket. The lever will return to HOLD when released. RAISE (5) - Move the lever to position (5) to raise the bucket. Release the lever to stop lifting the bucket. The lever will return to HOLD when released.Hydraulic Control Lever Lock
Lock (1) - Move the lever to position (1) to lock the hydraulic control levers. Unlock (2) - Move the lever to position (2) unlock the hydraulic control levers.Kickout Neutralizer Switch (If Equipped)
Push the bottom of the switch to activate the lift and tilt kickout positioners, for normal operation.Push the top of the switch to shut off the lift and tilt positioner kickout circuit.Third Function Top Clamp Lever
CLOSE (1) - Push the lever forward to close the clamp. Release the lever