SHAFT 6D2552 - Caterpillar

Graphical Display Module Event Code List
Table 1 lists the Advisor event codes and recommended responses. Use Cat ET to determine the active or logged event codes.
Table 1
MID 053
Graphical Display Module Event Codes
Event Code Warning Level Warning Description Required Operator Action
642 1 Display Button Pressed Too Long
861 1 Clock Manual Alignment Required Warnings and Indications
Warnings
The Cat Monitoring System will alert the operator when an event code is active. Event codes are activated in one of three warning levels according to the severity of the condition. The response of the monitoring system to these warning levels is shown in Table 2.
Table 2
OPERATION
Warning Category Warning Indications (1) Required Operator Action Possible Result (2)
Amber LED Red LED Action Alarm Sounds
1 No immediate action required. The system needs attention soon. No harmful or damaging effects.
2 X Change machine operation or perform maintenance to the system. Severe damage to components.
3 X X Immediately perform a safe engine shutdown. Operator injury or severe damage to components.
(1) The active warning indications are marked with an "X".
(2) Possible result if no operator action is taken.Indications
When an abnormal operating condition occurs, the Cat ET status screen indicates that there is an active event.Event codes are displayed on Cat ET in the following format:
EXXXX Description of the code.
The "E" means that the code is an event code. The "XXXX" is a numeric identifier. The numeric identifier is followed by a description of the code.
Active event codes are listed in ascending numerical order, the code with the lowest number is listed first.
The active event code is removed from the list when the condition is no longer present.Logged Event Codes
Every event code is logged in the ECM memory. Logged event codes are listed in chronological order, the most recent code is listed first.A logged code is cleared from memory when the code is manually cleared. Always clear logged event codes after investigating and correcting the problem which generated the code.Troubleshooting
Perform the following steps to troubleshoot an event.
Obtain the following information from the operator:
Event
The time of the event
Operating conditions at the time of the event
Dealer or customer installed systems that could cause the event
Verify that the event is not due to normal machine operation or operator error.
Check all fluid and oil levels.
Troubleshoot and repair the cause of any active diagnostic codes.