SHAFT AS-ROCKER ARM 6I0901 - Caterpillar

There are four serial numbers on an XQ Rental Generator Set. The serial numbers identify the engine, the generator, the enclosure, and the trailer. All four serial numbers should be located and recorded in this booklet for future reference.Other important identification information includes the engine Information Plate, and the generator Name Plate.Engine Identification
Caterpillar engines are identified with serial numbers, fuel system setting numbers, and arrangement numbers. In some cases, modification numbers are used. These numbers are shown on the Serial Number Plate and the Information Plate mounted on the engine.Caterpillar dealers need all of these numbers to determine which components were included on the engine when the engine was assembled at the factory. This permits accurate identification of replacement part numbers.
The engine Serial Number Plate (1) is located on the upper left rear of the cylinder block. The engine Information Plate (2) is located on the left side of the cylinder block.Serial Number Plate
Typical engine Serial Number Plate. The engine serial number, model, and arrangement number are stamped on the Serial Number Plate.Information Plate
Typical engine Information Plate. The engine's maximum altitude, horsepower, high idle, full load rpm, and other information is stamped on the Information Plate.Generator Identification
Serial Number Plate
The generator Serial Number Plate is located on the barrel of the generator.
Typical generator Serial Number Plate. The generator serial number, model, and arrangement number are stamped on the Serial Number Plate.Name Plate
The generator Name Plate is installed on the plastic cover over the main power connections on the distribution panel.
Typical generator Name Plate. The generator set model, generator rating, and other generator data are stamped on the Name Plate.Control Panel Identification
The controls for your generator will be located in a control panel. The control panel is located in a cabinet above the distribution panel. The part number of the control panel is located on a nameplate inside the panel.Engineering prints are shipped inside each control panel. Refer to the Service Manual or contact your Caterpillar dealer for additional copies of the prints. Consult with your Caterpillar dealer for replacement parts. Your Caterpillar dealer has all of the latest information on parts availability.Enclosure Identification
Serial Number Plate
The enclosure Serial Number Plate is located at the rear distribution panel above the main circuit breakers.
Typical enclosure Serial Number Plate.Trailer Identification
Serial Number Plate
The trailer Serial Number Plate is located at the center of the bumper.
Typical trailer Serial Number Plate.Attachment Identification
Your XQ Rental Generator Set may be equipped with special attachments and options. Take the time to identify those items. Refer to the engine attachment list on the shipping invoice in the folder provided in the binder. The optional equipment can include:* Jacket Water Heater* Battery Charger* Generator Space Heater* Air Inlet Shutoff* Coolant Loss Sensor* 1724 Electronic Governor
Always determine the cause of the emergency shutdown before re-starting the engine.
Air inlet shutoff wiring diagram: terminal strip in EMCP II (1), 20 amp circuit breaker in EMCP II (2), air shutoff relay in EMCP II (3), and Rig Saver air shutoff (4).The air inlet shutoff has