SHAFT AS 6I8190 - Caterpillar

Illustration 1 g02026198
Schematic of the "Hydraulic Lock" solenoid
This diagnostic code is associated with the "Hydraulic Lock" solenoid. The FMI 03 diagnostic code means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed below:
The solenoid has failed.
The energize circuit of the solenoid is shorted to the +battery circuit.
The hydraulic lock relay has failed.
The Machine ECM has failed. This is unlikely.When this diagnostic code occurs, a warning is displayed on the Monitoring System and the Machine ECM disables the hydraulic system.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1160 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code of CID 1160 FMI 03 will be logged in the internal memory of the Machine ECM.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector J2 from the solenoid at the ECM.
Place a jumper between contacts 3 (wire A588-GN(Green)) and 5 (wire E564-PK(Pink)) of the hydraulic lock on relay.
At the machine harness connector for the ECM, measure the resistance from contact J2-27 (wire A588-GN(Green)) to all contacts that are used in the machine harness connectors for the Machine ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-27 (A588-GN(Green)) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE.
Inspect the contacts. Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Remove the jumper that was placed in the previous test.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 1160 FMI 03 diagnostic code is active. Expected Result:The CID 1160 FMI 03 diagnostic code is active.Results:
YES - The CID 1160 FMI 03 diagnostic code is active. The problem has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - The CID 1160 FMI 03 diagnostic code is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume