SHAFT 7C3261 - Caterpillar

Illustration 1 g00573861
Schematic For Action Alarm. (1) Locomotive - 410-WH: Marine Engines and Generator Engines - 025-GN.This diagnostic code is recorded when the Main Display Module reads the current of the circuit for the Action Alarm as below normal current. Also, this diagnostic code is recorded when the Main Display Module reads an open circuit with the Action Alarm. As a result of this action, the Action Alarm does not sound when the Action Alarm should sound.
Check The Alarm.
Disconnect the engine harness from the Action Alarm.
Place a jumper wire across the two leads of the Action Alarm of the engine harness.Expected Result: The FMI 05 diagnostic code should remain active.Results:
OK - The FMI 05 diagnostic code is still active. The Action Alarm is not causing the problem. Measure the resistance across the terminals of the Action Alarm. The resistance should be 200 100 ohms. If the resistance of the Action Alarm is good, but the alarm does not sound, proceed to Step 2.
Not OK - If the FMI 05 diagnostic code is not active, the Action Alarm has a problem. Measure the resistance across the terminals of the Action Alarm. The resistance should be 200 100 ohms. If the resistance of the Action Alarm is good, but the alarm does not sound, proceed to Step 2. If the resistance of the Action Alarm is not good, then replace the Action Alarm. Proceed to Step 2.
Check The Harness.
Turn the "ECS" switch to the OFF/RESET position.
Remove the jumper wire from the harness leads of the Action Alarm.
Reconnect the harness leads to the Action Alarm.
Disconnect the engine harness from the Action Alarm.
At the engine harness connector for the Main Display Module, measure the resistance from contact 4 to contact 2. Contact 2 is the ground.Expected Result: The resistance should be less than 300 ohms.Results:
OK - The resistance is less than 300 ohms. The harness resistance is correct. Proceed to Step 4.
Not OK - The resistance is greater than 300 ohms. The harness circuit is open. Proceed to Step 3.
Check The Harness. Disconnect the engine harness from the Action Alarm. Check for an open circuit between the Main Display Module (contact 4) and the lead of the Action Alarm (terminal 1). Also, check for an open circuit between the lead of the Action Alarm (terminal 2) and ground. If an open circuit is found, repair the harness or replace the harness.
Check The Main Display Module.
Turn the "ECS" switch to the OFF/RESET position.
Turn the "ECS" switch to the OFF/RESET position.
Reconnect the engine harness connector to the Main Display Module.
Reconnect the engine harness to the Action Alarm.
Turn the "ECS" switch to the COOLDOWN/STOP position.Expected Result: The FMI 05 diagnostic code should not be active.Results:
OK - The FMI 05 diagnostic code is not active. The Main Display Module is not causing the problem. The problem is intermittent. The probable cause is a poor electrical connection at the harness connectors or a damaged harness. Check the harness for damage and clean the connectors when cleaning