SHAFT 7D7602 - Caterpillar

7D7602 SHAFT Caterpillar parts 120, 140

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7D7602
7D-7602
7D7602

Weight: 127 pounds 57 kg.

Buy SHAFT 7D7602 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 7D7602:

MOTOR GRADER 120 140 Caterpillar

Number on catalog scheme: None

For full view, you need register

Information:

Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Illustration 1 g06159691
Remove oil filler plug (1).
Remove drain plug (3) on the bottom of the winch. Allow the oil to drain into a suitable container.
Inspect the plug seal. If necessary, replace the plug seal.
Clean the drain plug and install the drain plug.
Remove oil level plug (2).
Fill the oil compartment until oil is visible at the bottom of the opening for the oil level plug. See Operation and Maintenance Manual, "Refill Capacities".
Clean the vent plug that is in the filler plug. Use a clean nonflammable solvent.
Clean the filler plug and install the filler plug.
Run the engine at low idle. Maintain the oil level so that the oil level is visible at the bottom of the opening for the oil level plug.
Install the oil check plug.Note: Perform this procedure at the “Initial 500 Service Hours” interval for newly installed winches. Perform this procedure at “Every 1000 Service Hours” interval as a normal operation. A winch filter plugging event code will also require this procedure.