SHAFT AS-DRIVE 7E0195 - Caterpillar

Duo-Cone Break-In Procedure
The Break-In procedure must be run as a continuous section. Time that is required to carry out the Break-In procedure is 25 minutes. This procedure should be performed when the wheels turn for the first time. This procedure may also be done after you purge the air from the brake system as long as the wheels are not turned before you purge the air from the brake system. Follow the break-in procedure in the sequence that is mentioned below:Note: If testing is performed on stands instead of tires, do not exceed SECOND GEAR.
Operate the machine at low idle rpm in the FIRST GEAR for five minutes.
Operate the machine at high idle rpm in the FIRST GEAR for five minutes.
Operate the machine at high idle rpm in the SECOND GEAR for five minutes.
Operate the machine at high idle rpm in the THIRD GEAR for five minutes.
Operate the machine at high idle rpm in the FOURTH GEAR for five minutes.