SHAFT-IDLER 7N3005 - Caterpillar

Obey all state and local laws governing the weight, width and length of a load.Remove the starting aid (ether) cylinder, if equipped.Make sure the cooling system has proper antifreeze if moving machine to a colder climate.Observe all regulations governing wide loads.
Illustration 1 g00614904
Before you load the machine, block the trailer wheels or the rail car wheels, as shown.
Retract the ejector blade when you transport the machine. Note: In wet or icy conditions, operator can engage the manual setting of the Operation and Maintenance Manual, "Monitoring System (Traction Control)" before loading the machine onto a trailer to assist loading.
When the machine is positioned on the transport machine, install the steering frame lock. Refer to Operation and Maintenance Manual, "Steering Frame Lock".
Move the transmission control to the N position.
Engage the parking brake.
Shut off the engine.
Turn the engine start switch to the OFF position and remove the key.
Turn the battery disconnect switch to the OFF position and remove the key.
Lock the cab door. Attach any vandalism protection.
Block the wheels. Secure the machine with tie-downs. Refer to Operation and Maintenance Manual, "Lifting and Tying Down The Machine".
Illustration 2 g02453453
Fold the mirrors (1) to the proper orientation toward the cab. Perform this step on both sides of the machine. Note: If necessary, loosen adjustment bolts, and retighten the bolts when the mirrors are in the folded position.
Loosen adjustment for antenna (2) and lower the antenna. Tighten the antenna adjustment in the lower position.
Loosen band clamp and remove the exhaust tube (3) from the exhaust stack. Store the exhaust tube and clamp in the cab. Cover the exhaust opening in order to prevent the turbocharger from windmilling in transit.
Perform a walk-around inspection . Travel at a moderate speed. Observe all speed limitations when you are roading the machine.Consult your Caterpillar dealer for shipping instructions for your machine.