SHAFT 7P6353 - Caterpillar

Illustration 1 g06276730
(1) Heat shield
(2) Harness assembly
(3) NOx sensor probeNote: During installation and handling of the sensor, follow the parameters listed below:
Do not expose the sensor to any fluids.
Do not contact the sensing element when power is applied to the sensor. Contact with the sensing element may result in injury. The sensing element is heated to a minimum of 100° C (212° F).
Do not use any lubricant on any part of the sensor other than the threads. Do not use unapproved thread lubricant. Do not apply additional anti-seize to new parts. If additional anti-seize is necessary for pre-installation, use only nickel based anti-seize or non-metallic anti-seize. Apply anti-seize to the threads only and avoid contaminating the sensor head.
Do not use sensors that have been dropped or have been exposed to other forms of mishandling. Damage to the sensor may have occurred that is not visible.
Replace the sensor if damaged or faulty.To replace the NOx sensor, follow the steps listed below:
Remove heat shield (1).
Disconnect harness assembly and disconnect sensor cabling (2).
Use 468-8116 Slotted Socket (22mm) to loosen the sensor.
Remove NOx sensor probe (3).
Illustration 2 g03546277
Install inlet NOx sensor probe. Take precautions to prevent damaging the ceramic sensor element (4) when installing.
Ensure that the sensor is securely mounted.
Connect harness assembly and cabling.Note: Ensure that the NOx sensor is not covered with insulation. The insulation would trap heat in the sensor body and cable. This heat may cause sensor failure.
Install heat shield plate assemblies and bolts. Refer to Specifications, SENR3130, "Torque Specifications" for the proper torque.