SHAFT AS 8E3517 - Caterpillar

Air Starting Motor
If the starting motor fails, the engine may not start in an emergency situation. A scheduled inspection of the starting motor is recommended.The starting motor pinion and the flywheel ring gear must be in good condition in order for the engine to start properly. The engine will not start if the starting motor pinion does not engage the flywheel ring gear. The teeth of the starting motor pinion and the flywheel ring gear can be damaged because of irregular engagement.Inspect the starting motor for proper operation. Listen for grinding when the engine is started. Inspect the teeth of the starting motor pinion and the flywheel ring gear. Look for patterns of wear on the teeth. Look for teeth that are broken or chipped. If damaged teeth are found, the starting motor pinion and the flywheel ring gear must be replaced.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Inspect all of the components in the air circuit for the starting motor. Inspect all of the air lines and connections for leaks. If damaged teeth are found, the air circuit for the starting motor must be examined in order to determine the cause of the problem.Servicing the Air Inlet Screen
Illustration 1 g01948522
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury.
Note: Ensure that the air system is not pressurized.
Disconnect inlet air line to the starting motor (1).
Remove the retaining ring.
Remove the screen and clean the screen.
Reinstall the screen.
Reinstall the retaining ring.
Connect the inlet air line to the starting motor. Removal and Installation of the Starting Motor
Refer to the Service Manual, "Disassembly and Assembly" module for information on removing the starting motor and installing the starting motor.Consult your Caterpillar dealer for assistance and/or for options on replacement of the starting motor.