SHAFT GP-DRIVE 9C4207 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7575 Link Bracket 2
B - Loctite 5188 - Start By:
Remove the crankshaft rear seal.
Remove the aftercooler.
Remove the starters.
Illustration 1 g01219819
Disconnect clamp (1). Disconnect clamps (2). Remove tubes (3).
Illustration 2 g03349394
Remove bolts (4). Remove bracket (5). Repeat for the opposite side. Disconnect harness assemblies (6). Remove tube assemblies (7).
Illustration 3 g01219824
Remove bolts (8). Remove cover (9). Remove bolts (10). Remove cover (11).
Illustration 4 g01219825
Remove bolts (12). Remove cam gear (13).
Illustration 5 g01219847
Remove bolts (14) to disconnect bracket (15) from air intake manifold (16). Repeat for the opposite side.
Illustration 6 g03349403
Disconnect hose assembly (17).
Illustration 7 g01220568
Disconnect harness assembly (19). Remove bolts (18). Remove cover (20).
Illustration 8 g01220569
Disconnect harness assembly (23). Remove bolt (21). Remove crankshaft position sensor (22).
Illustration 9 g01220570
Attach Tooling (A) and a suitable lifting device onto flywheel housing (24). The weight of flywheel housing (24) is approximately 726 kg (1600 lb). Apply slight lifting tension on flywheel housing (24).
Illustration 10 g01220583
Remove bolts (25) that connect the oil pan to flywheel housing (24).
Illustration 11 g01220585
Remove bolts (26). Remove flywheel housing (24).Installation Procedure
Install flywheel housing (24) in the reverse order of removal.
Apply Tooling (B) to the mating surface of flywheel housing (24).