SHAFT-PLANETARY 9P8623 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-9517     Plug     4    
B     185-5192     Stud Protector     4    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn OFF the fuel supply to the engine.
Illustration 1 g01322145
Remove the protective cover from the lifting brackets. Use a paint stick to mark the location of the lifting brackets.
Remove tube assemblies (1). Use Tooling (A) to plug the openings in order to prevent debris from entering the fuel system.
Remove nuts (3) .
Remove lifting bracket (2) .Note: Store the lifting brackets in a clean dry place. Do not install the lifting brackets until it is necessary to lift the engine.
Install Tooling (B) on each cylinder head stud.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
B     185-5192     Stud Protector     4    
C     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Remove Tooling (B) from each cylinder head stud.
Install the engine lifting brackets on a 3608 Engine between the following cylinders:
Number 1 Cylinder and Number 2 Cylinder
Number 7 Cylinder and Number 8 Cylinder
Apply Tooling (C) on the threads of the cylinder head studs.
Illustration 2 g01322145
Put engine lifting bracket (2) in position on the cylinder head studs. Install nuts (3). Tighten the nuts to a torque of 2150 250 N m (1590 185 lb ft).Note: The brackets must be installed so that the pin holes in the clevis are in a horizontal plane.
Install tube assemblies (1) .
Turn ON the fuel supply.