SHAFT ASSEM. 9S9203 - Caterpillar

Diagnostics
Illustration 3 g06168584
(1) Fault code
(2) Fault description
Illustration 4 g03870476
Diagnostics screen
The Diagnostics menu option will show a complete list of all active events and the logged event codes and diagnostic codes.Codes and events that are contained in the system Diagnostics may be viewed at any time. The logged codes cannot be cleared until the Service Mode is enabled.Press the OK key while you are in the Diagnostics menu option to display the Diagnostic message screen.Each line that is listed contains the following information about that event or code:Fault Code (1) - Component Identifier or Failure Mode Identifier (CID-EID)Fault Description (2) - Diagnostic code identifierCommunicating Active Faults or Events
When the diagnostic message is acknowledged, a predetermined length of time passes before the message screen will appear on the monitoring system display again. This interval is dependent upon the severity of the warning level. Consult the appropriate warning category for the proper instruction.Configurations
Illustration 5 g06167903The Configurations menu will appear only if the operator enters the Service mode password through the Service mode menu. Service Configurations allow access to the following advanced settings:
Blade Installation
Max Track Speed: Forward/Reverse
Engine Idle Shutdown: Period/Disable
Engine Cool Fan Bypass: Installed/Not Installed
Rear Implement: Not Installed/Ripper/Winch
Stable Blade
ClockBlade Installation
The Blade Installation menu will display the following Blade Installation information:
Not Installed
Single Tilt S Blade
Single Tilt SU Blade
Power Angle Tilt
AngleMax Track Speed
Illustration 6 g06167955Engine Idle Shutdown
Illustration 7 g06168119The Engine Idle Shutdown menu will display the following options:
Set Range
DisableEngine Cool Fan Bypass
The Engine Cool Fan Bypass menu will display the following options:
Installed
Not InstalledRear Implement
Illustration 8 g06168169The Rear Implement menu will display the following options:
Not Installed
Ripper
WinchECM Summary
Illustration 9 g06168248The ECM Summary menu will display information for each ECM installed on the machine.This menu organizes the systems into the following five categories:
Engine
Aftertreatment
Machine
Implement
DisplayThe following information will be displayed for each ECM:
ECM Serial Number
HW Part Number
SW Part Number
SW Release Date
SW DescriptionParameters
Illustration 10 g06168303The Parameters menu will display the value of several sensors. This menu may be useful for troubleshooting purposes. Scroll down to navigate through the different systems monitored.This menu organizes the systems into the following seven categories:
Brake
Engine
Power train
Implement
Rear implement
Steering
MachineService Mode
To Enable Service Mode
Illustration 11 g06168600On the Service Mode page, highlight "Enable" and press the OK button. This will move the check mark and enable Service Mode.When Service Mode is enabled, previously hidden Service Mode items will be viewable in the Service menu. The scroll bar will appear due to the two new items (Configurations and Calibration) that appear in the menu.