SHAFT-GOVERNOR CONTROL 9T8056 - Caterpillar

TARGET="_parent">Fuel Tank Water and Sediment - Drain
Fuel Tank Water and Sediment - Drain
Tire Inflation - Check
Every 100 Service Hours or 2 Weeks
Axle Oscillation Bearings - Lubricate
Lift Cylinder Lower Bearings - Lubricate
Lift Cylinder Upper Bearings - Lubricate
Steering Cylinder Bearings - Lubricate
Initial 250 Service Hours
Electronic Unit Injector - Inspect/Adjust
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours or Monthly
Alternator Air Vent Line and Screen - Clean
Battery - Clean
Belt - Inspect/Adjust/Replace
Brake Accumulator - Check
Braking System - Test
Crankcase Guard Compartment and Power Train Guard Compartment - Clean
Differential and Final Drive Oil Level - Check
Engine Air Filter Service Indicator - Inspect/Replace
Engine Oil Sample - Obtain
Hydraulic System Oil Sample - Obtain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours or 3 Months
Cooling System Coolant Sample (Level 1) - Obtain
Differential and Final Drive Oil Sample - Obtain
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Filter - Replace
Transmission Oil Filter - Replace
Transmission Oil Sample - Obtain
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate
Battery Hold-Down - Tighten
Case Drain Screen (Strainer) (Implement Pilot Valve) - Clean
Case Drain Screen (Strainer) (Steering Pump, Hydraulic Fan Pump, Motor) - Clean
Drive Shaft Support Bearing - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Transmission Oil - Change
Every 1000 Service Hours or 1 Year
Service Brake Wear Indicator - Check
Every 2000 Service Hours or 1 Year
Brake Discs - Check
Differential and Final Drive Oil - Change
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Hydraulic System Oil - Change
Receiver Dryer (Refrigerant) - Replace
Steering Column Spline (Command Control Steering) - Lubricate
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 4000 Service Hours or 2 Years
Hydraulic System Oil - Change
Every 5000 Service Hours or 3 Years
Turbocharger - Inspect
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Electronic Unit Injector - Inspect/Adjust
Engine Water Pump - Inspect
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change