SHANK A 7J2063 - Caterpillar

Illustration 1 g06035356
Schematic Of Sensor Power Supply Voltage
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides +8 DCV to operate the sensors.This diagnostic code will be recorded when the transmission ECM reads the voltage for the circuit of the sensor supply as being above normal.The results of this diagnostic code are listed:
All the associated sensors will also log faults.The possible causes of the diagnostic code are listed:
+8 DCV (wire X800-OR(Orange)) is shorted to the +battery in the machine harness.
The ECM has failed. An ECM failure is unlikely.Test Step 1. CHECK FOR A SHORT TO THE +BATTERY.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the machine harness connectors for the ECM, measure the resistance between the contact for the +battery and the contact for the sensor supply voltage. See the schematic for more detailed information about the sensor power supply voltage for the sensor that is being tested.Expected Result:The resistance that is measured is greater than 5000 ohms.Results:
OK - The resistance that is measured is greater than 5000 ohms. The harness circuit is correct. The ECM may have failed.Repair: An ECM failure is unlikely. Perform this diagnostic code procedure again. Replace the ECM if the cause of the diagnostic code is NOT found. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance measures less than 5000 ohms. The machine harness has failed.Repair: There is a short between the +battery circuit and the circuit for the sensor power supply in the machine harness. Repair the machine harness or replace the machine harness.STOP