SHEAR-BLOCK 4775869 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    
B     1P-1861     Retaining Ring Pliers     1    Note: Refer to Specifications, "Water Pump" for specifications that are required during assembly.
Illustration 1 g00813948
Install seal (14), if the seal was removed during the disassembly procedures.
The following components are installed on shaft (9) :
Washer (13)
Bearing (12)
Spacer (11)
Bearing (10) Note: Check two bearings (10) and (12) for correct rotation.
Illustration 2 g00610140
Use a press and Tool (A) to install shaft assembly (5) into the water pump housing.
Use a press and Tool (A) to install impeller (8) onto shaft assembly (5) .
Illustration 3 g00610127
Use Tool (B) to install retaining ring (4) into the water pump housing.
Use a press and Tool (A) to install flange (3) onto shaft assembly (5) .
Illustration 4 g00610108
Install water pump pulley (2) onto the flange.
Install four bolts (1) in order to secure water pump pulley (2) to the flange.End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".