SHEET AS 2036671 - Caterpillar

Illustration 1 g02301576
Table 1
Item Qty Part Specification Description
- All bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all the pin bores and the bushings before assembly. After you assemble the bushings coat all the bores and the bushings with 5P-0960 Grease Cartridge.
1 6 166-1494 Lip Type Seal Lubricate the sealing lip of lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that lip of the lip type seals do not extend beyond the face of the boss.
2 2 396-3819 Bushing Install the bush in the bore so that the part number of each bush is facing outward.
Inside diameter is 80.20 0.02 mm (3.157 0.001 inch).
Installation depth is 9.2 0.8 mm (0.36 0.03 inch).
3 2 396-3817 Bushing Install the bush in the bore so that the part number of each bush is facing outward.
Inside diameter is 80.20 0.02 mm (3.157 0.001 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
4 8 451-2183 Nut Torque to 175 30 N m (129 22 lb ft).
5 1 254-3053 Pin Diameter is 79.850 0.025 mm (3.1437 0.0010 inch)
6 1 254-3052 Pin Diameter is 69.850 0.025 mm (2.7500 0.0010 inch).
7 2 087-5805 Pin Diameter is 79.850 0.025 mm (3.1437 0.0010 inch).
- - - Position the nut (8) to the distance of 0.5 0.5 mm (0.02 0.02 inch) past the end of the bolts (11). For locking, tighten the nut (9) against the nut (8).
10 - - During assembly of linkage group on the machine, rotate the rod end of the bucket cylinder to position the grease fitting away from the stick.