parts catalog

SHEET AS 2559938 - Caterpillar

2559938 SHEET AS Caterpillar parts SHEET
Alternative (cross code) number:
Caterpillar 2559938 SHEET AS

Buy SHEET AS 2559938 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Dipstick is located on the left side of the engine. 1. The oil level should be above the ADD mark on the dipstick. 2. Add oil, if necessary, through fill tube to bring the oil level to the specified level.Cooling System
Look at the Coolant Level
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
1. Remove the coolant fill cap slowly to relieve any pressure.2. Inspect the condition of the cap gasket. Replace the cap gasket if necessary. 3. Maintain the coolant within 13 mm (.5 inch) of bottom of fill pipe.4. Install the radiator cap.Clean Radiator
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from a folded core radiator. Clean as required by condition of radiator.The use of compressed air is preferred.Fuel Tank
Drain the Moisture and Sediment
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.
1. Open the drain valve and allow the moisture and sediment to drain.2. Close the drain valve.Back-up Alarm
Test For Proper Operation
1. With the disconnect switch on, apply the services brake and place the transmission control lever in REVERSE.2. The alarm should start to sound immediately. It will continue to sound until the transmission control lever is moved to NEUTRAL or FORWARD.Seat Belt
Inspect for Wear or Damage
Replace the seat belt every 3 years regardless of its condition or appearance.
1. Inspect the condition of the seat belt, buckle and slides.2. Inspect the mounting hardware.3. Replace the seat belt or any part of the mounting hardware, if it is worn or damaged.Indicators and Lights
Test and Inspect for Broken Gauges
1. Look for broken lights, indicator gauges or panel damage.2. Allow the engine to warm up at LOW IDLE for five minutes. To help speed the warmup of hydraulic components, engage and disengage all hydraulic implement controls.3. If the lights or horn did not come on, have necessary repairs made.Hydraulic Tank
Look at the Oil Level
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil can cause burns.Remove the fill cap only when the engine is stopped, and the cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure.
Never remove the cap from the implement hydraulic tank if oil is hot. Air can enter system and cause pump damage.
The hydraulic oil tank is located on the right rear of the machine. Add oil through the fill tube to maintain the oil level to the FULL mark in the sight gauge. All implements to

Parts sheet Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.