SHEET 3797654 - Caterpillar

Introduction
This special instruction contains the information that is needed to swap both Indicator Panels on the machines that are listed above.Do not perform any procedure in this publication or order any parts until you understand the information that is contained in this publication.Procedure
Prepare the machine.
Turn the engine start switch from the OFF position to ON position to perform the functional test. Indicators panel Left and Right will be "ON" and will be able to check location as follow:
Illustration 1 g03400163
(A) 375-5751 Indicator Panel (B) 375-5752 Indicator Panel
Match the Icons displayed in left 375-5751 Indicator Panel (A), and verify the Icons in the right 375-5752 Indicator Panel (B) .
If both left Indicator Panel (A) and right Indicator Panel (B) are oriented as in Illustration 1, no action is required. If the panels are switched, proceed to Step 5 to perform the rework to move the panels to the correct location.
Connect the steering frame lock.
Illustration 2 g03400177
(C) 9X-1046 Screw (D) 7Y-7256 Screw
Remove and retain six Screws (C) and two Screws (D) .
Illustration 3 g03400180
(E) Display Panel
Remove Display Panel (E) from the dash to gain access to the harness assemblies.
Illustration 4 g03400181
Illustration 5 g03400184
(F) Indicator Panel Harness Plug
Disconnect both Indicator Panel Harness Plugs (F) for Indicator Panels (A) and (B) .
Illustration 6 g03400186
Remove both Indicator Panels and by pressing from the rear center portion of the Indicator Panel.
Illustration 7 g03400188
(E) Display Panel
Swap both Indicator Panels and assemble by snapping Indicator Panels into Display Panel (E). Refer to Illustrations 7 and 1.
Illustration 8 g03400190
Connect indicator panel harness assemblies. Refer to Illustration 8.
Illustration 9 g03400192
Install Indicator Panels (A) and (B) to Display Panel (E) using hardware retained from Step 6.
Illustration 10 g03400194
Turn on the start key switch for proper testing.