SHEET 3992228 - Caterpillar

Table 1
Required parts    
1     210-2129     Linkage    
1     212-0854     Plate    
1     099-3649     Bolt    
1     8T-7547     Bolt    
3     6V-9189     Locknuts    
6     8T-4224     Hard Washers    Rework Procedure
Move the propel lever to the NEUTRAL position.
Engage the parking brake.
Illustration 1 g00852915
Remove side panel (1) that is located on the left side of the operator platform.Note: When possible, raise the platform.
Illustration 2 g00852629
Disconnect propel cable (2) from the plate on axle propel pump (3) .
Illustration 3 g00852216
Remove linkage assembly (4) from drum propel pump (5) and axle propel pump (3) .
Remove plate (6) that is located on the lever for axle propel pump (3) .
Adjust the length of the new 210-2129 Linkage to the length of the old linkage.
Illustration 4 g00852214
Attach the 212-0854 Plate (7) to the lever on axle propel pump (3) .
Attach one end of the new linkage to the lever on drum propel pump (5). Attach the other end of the linkage to plate (7) on axle propel pump (3). The levers for drum propel pump (5) and axle propel pump (3) should stay in the NEUTRAL position. If necessary, adjust the length of the linkage.Note: Use the top set of holes that are located on each lever in order to install the linkage.
Torque all connecting hardware to 27 7 N m (20 5 lb ft). Also, torque jam nuts (8) to 27 7 N m (20 5 lb ft).