SHIELD AS-EXH 1119360 - Caterpillar

Use Tooling (A) to support the boom.
Illustration 2 g00574267
Remove bolt (1), spacer (2), and cover (3) from the boom cylinder.
Illustration 3 g00574220
Disconnect lines (4) and (5) .
Remove clamps (6) and tube (7) from the boom cylinder.
Illustration 4 g00574224
Use the suitable lifting straps to support the boom cylinder.
Remove bolt (8) and spacer (9) .
Remove pin assembly (10) from the boom cylinder with a brass punch.
Illustration 5 g00574232
Remove bolt (11) and spacer (12) from the boom cylinder.
Remove pin assembly (13) from the boom cylinder with a brass punch.
Illustration 6 g00574258
Remove boom cylinder (14) from the boom with the suitable lifting straps. Weight of the boom cylinder is 27 kg (60 lb).Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     8S-8048     Saddle     1    
8S-7615 Pin     1    
8S-7641 Tube     1    
8S-7630 Stand     1    Note: Be sure that the boom pin bore and boom cylinder pins are thoroughly clean prior to installation of the boom cylinder.
Illustration 7 g00580622
Use Tooling (A) to support the boom.
Illustration 8 g00574258
Apply a thin coat of 1P-0808 Multipurpose Grease on the machined diameter of the pin bores and boom cylinder pins. Use the suitable lifting straps to support the boom cylinder into position. Weight of the boom cylinder is 27 kg (60 lb). Install boom cylinder (14) .
Illustration 9 g00574232
Install pin assembly (13) to the boom cylinder with spacer (12) and bolt (11). Tighten the bolt.
Illustration 10 g00574224
Install pin assembly (10) to the boom cylinder with spacer (9) and bolt (8). Tighten the bolt.
Illustration 11 g00574220
Install tubes (7) and clamps (6) to the boom cylinder.
Connect lines (5) and (4) .
Illustration 12 g00574267
Install cover (3), spacer (2), and bolt (1) to the boom cylinder.
Remove Tooling (A) from the boom.