SHIELD GP-EXHAUST 1511265 - Caterpillar

1. Maintain the oil level between the ADD and FULL marks on the dipstick (1) with the engine running.Maintain the oil level between the LOW and FULL marks on the engine stopped side of the dipstick (1) with the engine stopped.2. Remove the oil fill plug (2) and add oil if necessary.3. Clean and install the fill plug.4. Close the access door.Transmission Oil
Check the Oil Level
1. Open the access door located on the left side of the machine. 2. Maintain the oil between the LOW and FULL marks on the dipstick/fill cap at LOW IDLE.3. Remove the dipstick/fill cap and add oil if necessary.4. Clean and install the fill cap.5. Close the access door.Hydraulic Oil
Check the Oil Level
The hydraulic oil tank is located on the right side of the machine. 1. Maintain the oil level above the ADD COLD mark on the sight gauge (1). 2. Remove the oil fill cap (2) and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.Cooling System
Look at the Coolant Level
The radiator cap is located in the top hood of the machine at the right rear. 1. Remove the radiator cap slowly to relieve pressure.2. Maintain the coolant level to within 1 cm (1/2 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.3. Inspect the cap seal. Replace the cap if it is damaged.4. Install the cap.Fuel Tank
Drain the Water and Sediment
Drain valve is located at the left side of the machine under the fuel tank.1. Open the drain valve and allow the water and sediment to drain.2. Close the drain valve.Air Reservoir
Drain Water and Sediment
The drain valve is located under the air reservoir on the left side of the machine. Open the drain valve. Allow all condensation to drain. Close the drain valve.Walk-Around Inspection
Inspect Machine
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Keep a close watch for leaks. If leaking is observed, find the source and correct the leak. Check the fluid levels more frequently than the recommended periods if leaking is suspected or observed. 1. Inspect the engine precleaner screen for dirt and debris build-up. Remove dirt and debris from screen. 2. Inspect the bucket and linkage for damage or excessive wear. Repair if damaged. 3. Inspect the lights for broken bulbs and lenses. Replace if broken. 4. Inspect and remove any trash build-up in the engine compartment.5. Inspect the cooling system for leaks, faulty hoses and trash build-up. Correct any leaks and remove any trash from radiator. 6. Inspect the hydraulic system for leaks. Inspect the tank, hoses, tubes, plugs, joints and fittings. Correct any leaks. 7. Inspect differentials (front and rear) under machine for leaks.8. Inspect the final drives (front and rear) for leaks. 9. Inspect tires (front and rear) for damage