SHIELD AS-HEAT 1869638 - Caterpillar

Changing Machine Control Pattern By Four-Way Valve (If Equipped)
Whenever a change is made to the machine control pattern, also exchange the pattern card in the cab to match the new pattern.Check the machine control pattern for conformance to the pattern on the card in the cab. If the pattern does not match, change the card to match the machine control pattern before you operate the machine. Failure to do so could result in personal injury.
The machine control pattern can be changed to the ISO/JIS pattern, BHL pattern, MHI pattern, KOBE pattern, or the former SCM pattern. To change the joystick controls between the patterns, refer to Monitoring System for more information.
Illustration 1 g06136699
(A) ISO/JIS machine control pattern
(B) BHL machine control pattern
(C) MHI machine control pattern
(D) KOBE machine control pattern
(E) Former SCM machine control patternThe patterns on the left side of the illustration show the possible configurations for the left control lever. The patterns on the right side of the illustration show the possible configurations for the right control lever.
Stick Out (1) - Move the control lever to this position to move the stick outward.
Swing Right (2) - Move the control lever to this position to swing the upper structure to the right.
Stick In (3) - Move the control lever to this position to move the stick inward.
Swing Left (4) - Move the control lever to this position to swing the upper structure to the left.
Boom Lower (5) - Move the control lever to this position to lower the boom.
Bucket Dump (6) - Move the control lever to this position to dump the bucket.
Boom Raise (7) - Move the control lever to this position to raise the boom.
Bucket Close (8) - Move the control lever to this position to close the bucket.HOLD (9) - When the control lever is released from any position, the control lever will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a control lever diagonally.If the machine is equipped with a hydraulic hammer, the function of position (6) and of position (8) is different.Hydraulic Hammer Raise (6) - Move the control lever to this position to raise the hydraulic hammer.Hydraulic Hammer Lower (8) - Move the control lever to this position to lower the hydraulic hammer.If the machine is equipped with a grapple, the function of position (6) and of position (8) is different.GRAPPLE OPEN (6) - Move the control lever to this position to open the grapple arms.GRAPPLE CLOSE (8) - Move the control lever to this position to close the grapple arms.If the machine is equipped with a clamshell, the function of position (6) and of position (8) is different when in "Clamshell" mode.Note: When in "Clamshell" mode, the work tool can only be operated if Work Tool Select also has clamshell selected.CLAMSHELL OPEN (6) - Move the control lever to this position to open the clamshell.clamshell CLOSE (8) - Move the control lever to this position to close the clamshell.