SHIELD-HEAT 3066355 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00728048
Loosen hose clamp (2) and remove hose (1) from the air inlet elbow (3).
Illustration 2 g00728030
Disconnect plug (5) from the air temperature sensor.
Remove eight bolts (4). Remove air inlet elbow (3). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean the joint face on the air inlet elbow and the joint face on the air inlet cover with solvent. Apply 4C-9500 Quick Cure Primer on the joint face. Allow the primer to air dry for a minimum of three to five minutes.
Apply 1U-8846 Sealant to the joint face of the air inlet elbow and to the joint face of the air inlet cover. Installation of the air inlet elbow must be within ten minutes of application of the sealant.
Illustration 3 g00728030
Position air inlet elbow (3) on the air inlet cover.
Install eight bolts (4).
Connect plug (5) to the air temperature sensor.
Illustration 4 g00728048
Install hose (1) on air inlet elbow (3). Tighten hose clamp (2).