SHIELD GP-EXHAUST 4649809 - Caterpillar

Illustration 1 g01221229
Initial IQAN screen
Illustration 2 g01615541
Function input screen
At the initial IQAN screen, press function key (F2) once in order to access the function input screen. Press function key (F5) once in order to access the joystick input screen.
Illustration 3 g01615568
Joystick input screen
By using finger tip force, determine the values and record the values of the joysticks in each direction in Table 1 and Table 2.Note: When you must choose between 2 values, choose the value that is closest to 0.
Table 1
    +Y        
-X     Left Joystick SN     +X    
    -Y        
Table 2
    +Y        
-X     Right Joystick SN     +X    
    -Y        
Illustration 4 g01220518
Illustration 5 g01225529
Press the menu button (1) in order to activate the "Main" menu.
Illustration 6 g01204367
From the "Main" menu, press function key (F1) in order to select the "Adjust" menu.
Illustration 7 g01219191
Rotate knob (2) in order to highlight "Joystick Calibration". Press the center of knob (2A) in order to proceed to the next screen.
Illustration 8 g01219194
Rotate knob (2) in order to enter the required "PIN" code which will allow you to advance to the next screen. After the code has been entered, press the center of knob (2A) in order to save the selection.
Illustration 9 g01219195
Rotate knob (2) in order to highlight the desired direction from the list. Press the center of knob (2A) in order to proceed to the next screen.
Illustration 10 g01219196
Reference Table 1 and Table 2 while scrolling through the eight parameters for the joystick. Change the values of the parameters for the joystick to the values that were recorded in Table 1 and Table 2.
In order to adjust a value, rotate knob (2) until the desired value is reached.
Press the center of knob (2A) in order to save the value setting.
Be sure to save all setting selections. This can be done by pressing the center of knob (2A) .
Identify remaining joystick directions and repeat these steps until all above directions have been adjusted.
When calibration is complete, return to the "Main" menu by pressing menu button (1) .
Turn the engine start key to the OFF position.