SHIELD 6I0844 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01187367
The upper frame is inverted in order to show guard locations.
Remove guard (1).
Illustration 2 g01187368
Remove caps (2).
Illustration 3 g01187369
Disconnect hose (5).
Remove nuts (4) and (6).
Remove wiper arm assembly (3).
Illustration 4 g01187370
Remove caps (7).
Illustration 5 g01187371
Disconnect hose (8).
Illustration 6 g01187372
Disconnect harness assembly (9).
Remove bolts (10) and window wiper motor (11). Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 7 g01187372
Position window wiper motor (11) and install bolts (10).
Connect harness assembly (9).
Illustration 8 g01187371
Connect hose (8).
Illustration 9 g01187370
Install caps (7).
Illustration 10 g01187369
Install wiper arm assembly (3).
Connect hose (5).
Install nuts (4) and (6).
Illustration 11 g01187368
Install caps (2).
Illustration 12 g01187367
The upper frame is inverted in order to show guard locations.
Install guard (1).