SHIFT PRESSURE VALVE GROUP 9P6582 - Caterpillar

Illustration 1 g01192711
Use Tooling (A) and a suitable lifting device in order to position carriage (7) onto the ejector blade and the truck body. The weight of carriage (7) is approximately 210 kg (465 lb).
Illustration 2 g01192708
Illustration 3 g01193231
Illustration 4 g01192710
Install suitable blocking and Install bolts (10), washers (11), bolts (12) and washers (14) into carriage (7) in order to guide carriage (7) onto the ejector blade. Refer to the removal procedure for the position and the number of all of the washers.
Remove the blocking and Install nuts (13) onto bolts (12).
Tighten bolts (10) and tighten bolts (12).
Illustration 5 g01193229
Install spacer (9) and install bolt (8).
Illustration 6 g01192272
Remove Tooling (A) from carriage (7).
Illustration 7 g01193279
Install cover (5) and bolts (6).
Illustration 8 g01192269
Use the following procedure in order to adjust the ejector pitch rollers (1).
Illustration 9 g01193273
Illustration 10 g01193271
Illustration 11 g01193275
Outer lock ring, split rings, and inner lock ring
Loosen bolts (3). Remove three of bolts (3) that are installed into threaded holes in outer lock ring (2).
Install Tooling (B) into the threaded holes in outer lock ring (2) in order to loosen the outer lock ring, the inner lock ring, and split rings. Refer to illustration 11.
Remove Tooling (B) and Install three bolts (3). Do not tighten bolts (3) at this time.
Illustration 12 g01192705
Install two M10x1.5 bolts into boss (4). Use a suitable pry bar in order to adjust the position of the ejector pitch rollers. Refer to Operation and Maintenance Manual, "Ejector Blade Alignment - Check/Adjust" for the procedure to set the position of the spindle.
Remove the two M10x1.5 bolts that were installed in Step 8.d.
Illustration 13 g01193273
Tighten bolts (3) on lock ring (2). Refer to Operation and Maintenance Manual, "Ejector Blade Alignment - Check/Adjust" for the procedure to tighten the bolts.
Lower the floor rollers. Refer to Disassembly and Assembly, "Ejector Blade Floor Rollers - Install".
Ensure that the truck body is clear of any tools and foreign material. Turn the disconnect switch to the ON position. Start the engine and retract the ejector blade. Stop the engine.
Close the tailgate. Refer to Operation and Maintenance Manual, "Tailgate".
Check the alignment of the ejector blade. Refer to Operation and Maintenance Manual, "Ejector Blade Alignment - Check/Adjust".
Remove the steering frame locks. Refer to Operation and Maintenance Manual, "Steering Frame Lock".