SHIM 0306704 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement. Lubricate the O-ring seals with the lubricant that is being sealed.
Illustration 1 g00483828
Install valve spool (37), spring (36) and guide (35) into manifold valve (6) .
Illustration 2 g00483826
Position the O-ring seal and cover (34) to manifold valve (6). Install two bolts (33). Tighten the bolts to a torque of 30 4 N m (22 3 lb ft).
Illustration 3 g00483825
Install screen (32) into valve body (3) .
Illustration 4 g00483824
Install stop (31), spring (30), slug (29) and spring (28) into valve body (3). Install dowels (26) and (27) .Note: The bottom of dowel (26) should be 8.0 mm (.32 inch) below the outside bottom surface of valve body (3). Dowel (26) extends into stop (31) .
Illustration 5 g00483823
Install ball (25), spring (24) and retainer (23) into valve spool (14). Use Tooling (A) and install ring (22) into valve spool (14) .
Illustration 6 g00483822
Install slug (21) into valve spool (14) .
Illustration 7 g00483792
Install spring (20), spring (19), retainer (18) and ring (17) into valve spool (16) .
Illustration 8 g00483781
Install valve spool (16) and spring (15) into valve body (3) .
Illustration 9 g00483772
Install valve spool (14), spring (13), spring (12), spacers (11) and piston (10) into valve body (3) .
Illustration 10 g00483705
Position the O-ring seal and cover (9) to valve body (3). Install three bolts (8). Tighten the bolts to a torque of 30 7 N m (22 5 lb ft).
Illustration 11 g00483702
Position plate (7) onto manifold valve (6) and position valve body (3) onto plate (7) .
Illustration 12 g00483692
Position cover (5) onto valve body (3) and install 24 bolts (4). Tighten the bolts to a torque of 30 4 N m (22 3 lb ft). Install speed control valve (2) and directional valve (1) into valve body (3) .End By: Install the transmission hydraulic control valve. Refer to Disassembly and Assembly, "Transmission Hydraulic Control Valve - Install".