SHIM 0532902 - Caterpillar

Illustration 2 g00351252
Raise the lift arm until the front pin bores and the rear pin bores are level.
Place Tooling (A) in position under the lift arm, as shown.
Illustration 3 g00398799
Remove bolt (1), the washer, and the spacer from pin assembly (2) .
Attach a suitable lifting device to lift cylinder (3). The weight of lift cylinder (3) is approximately 250 kg (550 lb).
Place suitable blocking between lift cylinder (3) and the loader frame. Use the suitable lifting device to lower lift cylinder (3) onto the blocking.
Illustration 4 g02458436
Disconnect harness assembly (4) .
Remove bolts (5) and lighting assembly (6) .
Illustration 5 g01156752
Disconnect tube assembly (7) and remove fitting (8) .
Repeat Steps 3 through 8 for the other side of the lift arm.
Illustration 6 g01156764
Remove bolts (9) and disconnect hose assembly (10) .
Illustration 7 g01156753
Remove bolts (11) and disconnect hose assembly (12) .
Remove clips (14) and the brackets that secure harness assembly (13) to the lift arm.
Illustration 8 g01156754
Attach a suitable lifting device to lift arm (15). The weight of lift arm (15) is approximately 1390 kg (3065 lb).
Illustration 9 g01156777
Remove the bolt from pin assembly (16) .
Use a suitable lifting device to support Tooling (B). The weight of Tooling (B) is approximately 34 kg (75 lb). Use Tooling (B) to remove pin assembly (16) .
Repeat Steps 14 and 15 for the other pin assembly.
Use a suitable lifting device to remove the lift arm. The weight of the lift arm is approximately 1390 kg (3065 lb).
Illustration 10 g01156782
Remove lip seals (17) from both sides of lift arm (15) .
Illustration 11 g01156784
Use Tooling (C) to remove the bearings from the bucket end of the lift arm.
Illustration 12 g01156785
Use Tooling (D) to remove the bearing from the lift cylinder pin bores.
Illustration 13 g01156787
Use Tooling (E) to remove the bearings from the loader frame end of the lift arm.Installation Procedure
Install lift arm (3) in the reverse order of the removal.