AVSPARE.COM
parts catalog

SHIM 0542005 - Caterpillar



0542005 SHIM Caterpillar parts SHIM
Rating:
76
Alternative (cross code) number:
CA0542005
054-2005
0542005
Caterpillar 0542005 SHIM
Weight: 0.05 pounds 0 kg.
Information:
ID  31.8  mm
MATERIAL THICKNESS  .38  mm
OD  50.8  mm

Buy SHIM 0542005 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Topping off or mixing Cat ELC with other products that do not meet Caterpillar EC-1 specifications reduces the effectiveness of the coolant, shortens coolant service life, and may cause premature wear to components.Use only Caterpillar products or commercial products that have passed the Caterpillar EC-1 specification for pre-mixed or concentrate coolants. Use only Extender with Cat ELC.Failure to follow these recommendations can result in shortened cooling system component life.
When a Caterpillar Extended Life Coolant (ELC) is used, an Extender must be added to the cooling system.
Illustration 1 g06201310
(1) Cooling system pressure cap access cover
(2) Cooling system pressure capThe cooling system pressure cap is at the front of the engine enclosure forward of the engine air precleaner.
Open cooling system pressure cap access cover (1) to access cooling system pressure cap (2).
Slowly loosen the cooling system pressure cap to relieve system pressure. Remove the cooling system pressure cap.
Use a 8T-5296 Coolant Test Kit to check the concentration of the coolant. If necessary, adjust the concentration of the coolant.
Illustration 2 g06201312
(3) Cooling system drain valve
(4) Cooling system drain hose
If necessary, drain enough coolant from the cooling system to allow the addition of the Extender. The cooling system drain valve (3) is mounted on the left-hand frame rail behind the rear axle. If equipped, remove the bottom guard to access the cooling system drain valve (3).
If coolant must be drained from the cooling system, position a suitable container beneath cooling system drain hose (4). Open cooling system drain valve (3). Allow sufficient coolant to drain into the container.
Close the cooling system drain valve (3) and install the bottom guard.
Add 3 L (100 fl oz) of Extender to the cooling system.
Check the coolant level.Reference: Refer to Operation and Maintenance Manual, "Cooling System Level - Check" for the correct procedure.
Install the cooling system pressure cap (1). Close the cooling system pressure cap access cover (2).


Parts shim Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.