SHIM 0774471 - Caterpillar

Illustration 1. Former design and new design of the E-Stick pedal linkage. The parts and instructions that are needed to replace the E-Stick pedal linkage are provided in the table and the text that follow. Replacement Instructions1) Remove the current fixed plate that is used as the linkage between the E-Stick pedal assembly and the control valve stem. This is done by removing the two clips and the two pins that secure the plate.2) Assemble the following components as shown in Illustration 2:* Ball Joint (7)* Rod (4), for 416C, 426C and 436C machines; or Rod (5), for 428C and 438C machines* Rod End (8)* Locknuts (2) - Qty. 23) Adjust the length of the rod assembly for the machine that is being serviced. See Illustration 3.4) Install the ball join-end of the rod assembly to the shaft assembly. Use washer (1) and locknut (6).5) Install the rod end-end of the rod assembly to the stem of the control valve. Use pin (3) and clip (9).6) Operate the E-Stick pedal in order to check for correct operation of the linkage. Re-adjust the length of the rod assembly if necessary. 7) Tighten nuts (2) to secure the adjustable rod assembly for the adjusted length.
Illustration 2.The new adjustable rod assembly for the E-Stick pedal linkage.
Illustration 3.The overall length of the adjustable rod assembly with the 155-6011 Rod (4) for use on 416C, 426C and 436C machines, and with the 160-0837 Rod (5) for use on 428C and 438C machines.Dimension A = 133 mm (5.0 inch)Dimension B = 142 mm (5.5 inch)COPYRIGHT 1999 CATERPILLAR ALL RIGHTS RESERVED