SHIM 0950167 - Caterpillar

Illustration 1 g00040462
Check the track adjustment. Check the track for wear and for excessive dirt buildup.
Grease is under high pressure.Grease coming out of the relief valve under pressure can penetrate the body causing injury or death.Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened.Loosen the relief valve only one turn.
Move the machine forward. Allow the machine to coast to a stop without the use of the service brakes. Adjust the tracks while you are in the machine's typical operating conditions. If packing conditions prevail on the workplace, the tracks should be adjusted with packing material.
To measure the sag in the track, stretch a string over the grousers that are between the sprocket and the front idler. Take the measurement from the string to the top of the grouser at the maximum measurement. Dimension (2) is the maximum distance between the string and the grouser.
Illustration 2 g00512026
Track adjustment without carrier rollersIf a machine does not have carrier rollers, the sag in the track is measured between the sprocket and the front idler. The correct adjustment of dimension (2) is 155 10 mm (6.0 .40 inch).
Illustration 3 g00511982
Track adjustment with carrier rollersIf the machine is equipped with a carrier roller, the correct adjustment of dimension (3) and dimension (4) is 70 10 mm (2.75 .40 inch).Loose Track Adjustment
Illustration 4 g00040335
Do not attempt to tighten track when dimension (1) is 160 mm (6.3 inch) or more.Contact your Caterpillar dealer for track service or instructions.
Remove the access cover.
Illustration 5 g00574414
Add multipurpose grease (MPGM) through track adjustment valve (5). Add the MPGM until dimension (2) is correct.
Operate the machine back and forth in order to equalize the pressure. Allow the machine to coast to a complete stop. Do not use the brakes.
Remeasure dimension (2) .Tight Track Adjustment
Loosen relief valve (6) by one turn of 360 degrees. Allow the grease to escape.
Close the relief valve.
Add MPGM through track adjustment valve (5). Add grease until dimension (2) is correct.
Install the access cover.Bolt Torque for Track Shoes
The torque requirement for track shoe bolts is 870 70 N m (650 50 lb ft). Tighten the bolts for an additional 120 degrees. If you are using bolts with a master link, tighten the bolts to a torque of 870 90 N m (650 50 lb ft). Then, tighten the bolts for an additional 180 degrees.