SHIM 1043288 - Caterpillar

Illustration 1 g01245215
Install seal (21) and O-ring seal (20) into seal retainer (10) . Position seal retainer (10) onto the pivot shaft.
Illustration 2 g01245366
Apply clean oil to sleeve bearing (22) that is positioned in track roller frame (16) .
Illustration 3 g01245713
Illustration 4 g01245722
Apply clean oil to bearing sleeve (23) and to O-ring seal (19) . Position O-ring seal (19) to retainer assembly (18) .
Attach a suitable lifting device to retainer assembly (18) to position retainer assembly (18) to track roller frame (16) . The weight of retainer assembly (18) is approximately 31 kg (68 lb).
Install retainer assembly (18) , the washers, and bolts (17) .
Illustration 5 g01244376
Attach Tooling (A) to track roller frame (16) to position track roller frame (16) to the machine. The weight of track roller frame (16) is approximately 4354 kg (9600 lb). Install track roller frame (16) .
Illustration 6 g01244299
Install thrust ring (15) (not shown), plate (14) and bolts (13) . Tighten bolts (13) to a torque of 270 40 N m (200 30 lb ft).
Illustration 7 g01244111
Position seal retainer (10) and install bolts (9) .
Illustration 8 g01244084
Apply Tooling (C) to the pin bore and install pin (8) (not shown), hard washers (7) , and bolts (6) . Install bolts (5) and nuts (4) .
Illustration 9 g03717154
Tighten bolt (5A) to a torque of 1600 200 N m (1180 148 lb ft).
Tighten bolt (5B) to a torque of 1600 200 N m (1180 148 lb ft).
Torque bolt (5A) again to a torque of 1600 200 N m (1180 148 lb ft).
Torque bolt (5B) again to a torque of 1600 200 N m (1180 148 lb ft).
Repeat Step 10 thru Step 13 for opposite side of the machine.
Illustration 10 g01244264
Install cover (12) , the washers, and bolts (11) .
Illustration 11 g01243981
Illustration 12 g01243980
Lower Tooling (B) at the front of the machine and lower Tooling (B) at the rear of the machine.
If the oil was removed from the recoil spring and the bearing compartment, fill the compartment with oil to the correct level.End By:
Connect the track.
Install the pipelayer frame or the counterweight frame.