SHIM PACK 1080058 - Caterpillar

Illustration 1 g01075843
(1) Receiver
(2) Harness connector Receiver (1) has an input and an output. The input is a radio signal from the transmitter. The output is an electrical signal or a Pulse Width Modulated (PWM) electrical signal to the interface control module.When a function is selected on the transmitter, a radio signal is sent to receiver (1). Receiver (1) will interpret the radio signal and send an electrical signal or a PWM electrical signal through harness connector (2) and the electrical harness to the interface control module. The interface control module causes a machine function to occur.
Illustration 2 g01064346
Receiver display
(3) Remote control function LED
(4) Status LED
(5) Power LED
(6) Receive signal LED
(7) Valid data LED
(8) Battery low LED The display on receiver (1) consists of 28 Light Emitting Diodes (LED). There are 24 remote control function LED (3) and four status LED (4). Remote control function LED (3) each have an individual function. Remote control function LED (3) will be on when a function is selected on the transmitter.Power LED (5) will be on when the remote control switch in the operator station is in the ON position.Receive signal LED (6) will be on when receiver (1) is operating correctly and the transmitter is on and in radio signal range.Valid data LED (7) will be on when receiver (1) is receiving correct data from the transmitter.Battery low LED (8) will be on when the machine electrical system voltage drops below approximately 13 volts.