1274197 SHIM Caterpillar parts
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
Rating:
Alternative (cross code) number:
CA1274197
127-4197
1274197
CA1274197
127-4197
1274197
Weight: 0.01 pounds 0 kg.
Information:
ID
27.8
mm
MATERIAL THICKNESS
.8
mm
OD
38.5
mm
TRACK-TYPE TRACTOR, WHEELED EXCAVATOR,
Compatible equipment models: 1274197:
Number on catalog scheme:
6
For full view, you need register
Information:
Illustration 1 g02034913
Schematic of the shutdown relayThis diagnostic code is recorded when the Computerized Profiler Control ECM detects an above normal voltage of the solenoid circuit for the shut down relay.The possible causes of this diagnostic code are listed below:
The energizer circuit of the solenoid is shorted to the +battery.
The ECM has failed. This is unlikely.System Response:The machine response is listed below:
A Category 3 warning is shown on the Computerized Monitoring System (CMS) for the relay which affects the propulsion, steering or rotor control.
A Category 2 warning is shown on the Computerized Monitoring System (CMS) for the relay.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 322 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE ENERGIZER CIRCUIT OF THE RELAY FOR A SHORT TO +BATTERY.
Turn the key start switch to the OFF position.
Disconnect the machine harness from the relay and the ECM.
Disconnect the machine harness connector from the ECM.
While the shutdown relay is tested the emergency Stop should not be activated.
At the ECM machine harness connector, measure the resistance from the energizer circuit or signal contact 85 (wire L953-OR) to all possible sources of +battery. The possible sources of positive voltage are contacts 1, 10, 11, 31, 32, 33, 34, 35, 36, 37 and 38.Expected Result:Each resistance should be greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - The resistance is not greater than 5000 ohms. There is a short in the machine harness. The short is between the signal contact 85 (wire L953-OR) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the key start switch to the ON position.
Enter diagnostic mode of the Computerized Profiler Control ECM and clear all inactive diagnostic codes.
Operate the machine.
Check the status of the CID 322 FMI F03.Expected Result:The CID 322 FMI F03 is active.Results:
OK - The CID 322 FMI F03 is active. The diagnostic code has not been corrected. Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. Refer to the Electrical System Schematic for this machine and check all involved wiring harness connectors and wiring. Ensure that the connector contacts are clean. Also, ensure that the connector contacts are in good condition. Ensure that all the wiring of the machine harness are in good condition. If the cause of this diagnostic code is not found, replace the Computerized Profiler Control ECM. See the Testing and Adjusting, "Electronic Control Module (ECM) − Replace" Story in this manual.STOP
NOT OK - The CID 322 FMI F03 is not active. The diagnostic code
Cat SIS web machinery list:
Parts shim Caterpillar catalog:
315, 315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318D L, 318D2 L, 318E L, 323D L, M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318C
315, 315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318D L, 318D2 L, 318E L, 323D L, M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318C
1090, 1190, 1190T, 1290T, 2290, 2390, 2391, 2491, 311D LRR, 312D, 312E, 314D LCR, 314E LCR, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318D L, 318D2 L, 318E L, 320 L, 320B...
1090, 1190, 1190T, 1290T, 2290, 2390, 2391, 2491, 311D LRR, 312D, 312E, 314D LCR, 314E LCR, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318D L, 318D2 L, 318E L, 320 L, 320B...
1390, 2590, 315, 315B L, 317, 317B LN, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320D, 320E LN, 320N, 321D LCR, 322, 322 FM L, 322 LN, 322B L, 322B LN, 322C, 322C FM, 323D L, 323D LN, 323D SA, 323E L, 3...
1390, 2590, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, ...
1390, 2590, 315, 315B, 315B FM L, 315B L, 315C, 315D L, 317, 317B LN, 318B, 318C, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 307, 307B, 307C, 308C, 308E SR, 320C, 322, 322 FM L, 322B, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D L, 324D LN, 324E, 324E L, 3...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 307, 307B, 307C, 308C, 308E SR, 320C, 322, 322 FM L, 322B, 322B L, 322B LN, 322C, 322C FM, 324D FM, 324D L, 325, 325 FM L, 325 L, 325 LN, ...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 307, 307B, 307C, 320C, 322, 322 FM L, 325, 325 FM L, 325 L, 325 LN, 325B L, 325C, 325C FM, 325C L, 325D FM, 325D FM LL, 325D MH, 330, 330 ...
303, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304D CR, 304E, 311B, 311C, 311D LRR, 311F LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313B, 313D, 313D2, 313D2...
315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 320C L, 320D, 320D FM, 320D F...
1274196
SHIM
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
1274195
SHIM
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
1223126
SHIM
M312, M315, M318, M320
M312, M315, M318, M320
1223121
SHIM
M312, M315, M318, M320
M312, M315, M318, M320
1183578
SHIM
M318, M320
M318, M320
1183577
SHIM
M318, M320
M318, M320
1378432
SHIM
M312, M315
M312, M315
1253212
SHIM
M312, M315
M312, M315
1253211
SHIM
M312, M315
M312, M315
1253210
SHIM
M312, M315
M312, M315
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
1274198
SHIM
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...
CB-534C, CB-534D, CB-54, CB-564D, CB-634C, CB-634D, CB-64, CD-54, CP-433C, CS-431C, D3G, D3K XL, D3K2 LGP, D4G, D4K XL, D4K2 XL, D5G, D5K LGP, D5K2 XL, M312, M313C, M313D, M315, M315C, M315D, M315D 2,...