SHIM PACK 1380428 - Caterpillar

Table 1
Required Tools    
Description    Qty    
Measuring Tape     1    
Stopwatch     1    
Illustration 1 g00746675
Position the machine on level ground. Refer to Illustration 1.
Load the bucket.
Raise the boom until the top stick pin is the same height as the boom foot pin.
Fully extend the bucket cylinder.
Fully retract the stick cylinder.
Extend the stick cylinder rod 70 mm (2.8 inch) from the fully retracted position.
Measure each cylinders length from cylinder pin to cylinder pin.
Stop the engine.
Leave the machine in this position for three minutes. Measure each cylinders length from cylinder pin to cylinder pin for drift.
Table 2
Cylinder Drift (Loaded Bucket)    
Item     New     Rebuild     Service Limit    
Boom Cylinder    
6.0 mm (0.24 inch) or less    
12.0 mm (0.47 inch) or less    
24.0 mm (0.95 inch) or less    
Stick Cylinder    
10.0 mm (0.4 inch) or less    
15.0 mm (0.6 inch) or less    
25.0 mm (1.0 inch) or less    
Bucket Cylinder    
10.0 mm (0.4 inch) or less    
15.0 mm (0.6 inch) or less    
25.0 mm (1.0 inch) or less